How do you hook up a dish tv box to a Mitsubishi projection tv?

I have a 1993 mitsubishi projection tv model #vs-4562 the book tells me that i need a coaxial cable hooked into both antenna a %26amp; b with a splicer connecting it to a cable box but there is no output place to hook up a cable to the dish cable box does anyone konw if there is another way to hook up this tv?





Thanks!|||Hopefully you haven't UNSCREWED all the cabling the Satellite company installed....that's real fun trying to figure out which RF cable is actually connected "TO satellite"





If you haven't unscrewed all the wires from your box, then they should be exactly where they should be for a picture.





YOU WANT to connect the "OUT TO TV" connector TO your TV set.....OR your Video OUTPUT on your satellite to your TV's Video INPUT (use your TV's remote, and use the input button to roll thru the inputs to get the picture, and please, MAKE SURE your TV and the Satellite are BOTH turned on!)





And you only need to connect it to ONE antenna jack on the TV set. Antenna A or Antenna B....


You're not using PIP, so you don't need to connect it to BOTH.





As for the satellite connector, it's going to be the one NORMALLY coming out of your wall... it can be a single wire OR (normally) it's a DOUBLE WIRE....Only use this paragraph IF you unscrewed ALL the cabling from the box. IF you don't see "Progress 1 of 5, 2 of 5, 3 of 5" within a minute of connection, swap the double wire around....the 2nd WIRE on that double wire feeds the 2nd TV set in your home...and that connection goes to the box's connector with the


%26lt;2 in a box%26gt; connector..





Need a walk-through? Best to contact the satellite company if it's a NEW install....If it isn't E-mail me.